P1435
P1435 on Peugeot — Poor performance with the service light on and an ‘Engine fault: have the vehicle repaired’ message
Code P1435 reports a communication fault with the diesel particulate filter additive management system. On the Peugeot 208 1.4 HDI it appears together with numerous other network faults when the sensor built into the battery negative cable is malfunctioning.
- System
- Electronics
- Component
- Sensor integrated into the battery negative cable
- Fault
- The service light is on the instrument cluster, an ‘Engine fault: have the vehicle repaired’ message appears on the display and performance is reduced.
- Typical symptoms
-
- Reduced vehicle performance
- Service light on
- ‘Engine fault: have the vehicle repaired’ message on the central display
- Numerous control unit communication faults are stored together in the diagnostic memory
- Vehicles affected
-
- Peugeot 208 (C) 1.4 HDI 8v
- Main code
-
- P1435 Fuel additive management system - communication fault
- Related codes
-
- P1A99 Start&Stop starting system - supply voltage too high
- P1A9C Start&Stop starting system - capacitor
- U1218 CAN data bus - incorrect signal
- U1F1B LIN2 network fault
- U1F3C Loss of communication with the diesel additive pump
- U1F40 Loss of communication with the battery state-of-charge unit
- U1802 Vehicle speed information fault - message missing
- B10FF Steering wheel integrated controls, upper left-hand module dial fault - inconsistent or invalid value
On this fault the diagnostic tool often returns several codes together.
- Solution
-
See the repair procedure verified on Sema Repair.
The cause and the repair are on Sema Repair
On Sema Repair this code is linked to verified case studies, with the confirmed cause case by case, the job step by step, indicative times, the manufacturer's notes and a photograph of the component with the point of intervention highlighted.